EN2030 Fossfex - Autumn Fairy

PIECE PROFILES

EN2030 - Fossfex - Autumn Fairy

NUMBER

EN2030

NAME

FOSSFEX

TITLE

AUTUMN FAIRY

SCULPTOR

ANDREW BILL

HEIGHT

14cm (5.5")

RELEASED

July 1989

RETIRED/SOLD OUT

March 31st 1992

LIMITED

Open Edition

NUMBER ACTUALLY MADE

-

ORIGINAL SELLING PRICE (£)

£47.00

BOOK

Wrath of the Ice Sorcerer

PAGE

84

CHAPTER

On Thin Ice

PICTURE

After Page 4

OTHER INFORMATION

The very first wings that were tried for this piece were made out of clear resin but it was thought that they didn't look right as they looked far to heavy for the pieces so it was decided to source a thin plastic wing from a supplier outside of the factory. whilst these looked ok they weren't really liked at the factory.
The fairies were retired to make way for new pieces and not because of production problems as I have been told before.

Thanks to Phil & Dea Holland for the above information

Use the arrows below to navigate to the next or last piece - Only works to go through the full catalogue - If searching by section then use your browsers navigation arrows to return to previous page

NUMBER	EN2030
NAME	FOSSFEX
TITLE	AUTUMN FAIRY
SCULPTOR	ANDREW BILL
HEIGHT	14cm (5.5")
RELEASED	July 1989
RETIRED/SOLD OUT	March 31st 1992
LIMITED	Open Edition
NUMBER ACTUALLY MADE	-
ORIGINAL SELLING PRICE (£)	£47.00
BOOK	Wrath of the Ice Sorcerer
PAGE	84
CHAPTER	On Thin Ice
PICTURE	After Page 4
OTHER INFORMATION	The very first wings that were tried for this piece were made out of clear resin but it was thought that they didn't look right as they looked far to heavy for the pieces so it was decided to source a thin plastic wing from a supplier outside of the factory. whilst these looked ok they weren't really liked at the factory. The fairies were retired to make way for new pieces and not because of production problems as I have been told before. Thanks to Phil & Dea Holland for the above information